Balboa System Bp7 with 4Kw Heater G4361-01

Balboa System Bp7 with 4Kw Heater G4361 replaces G4361-01, G4361-02 and other software versions. Ships as latest, backwards compatible spa pack. Also used to replace select control systems in Canadian Spas and other models.

Free Shipping to anywhere in Canada.

Supports all TP and SpaTouch topsides
Supports all BP ancillary products (ControlMySpa, BBA, CZ and Status Pro)
Plug-N-Click Heater

FEATURES:
7 relays allow BP7 to operate in 32 different setups, which can power a spa with 1-4 pumps
BP7 can replace any Balboa BP System while using the existing topside that is already installed on the spa (some exceptions may apply)
BP7 can replace any Balboa VS or EL System when you match it with any TP or SpaTouch topside panel (some exceptions may apply)
BP7 can replace any Balboa or other brand's non-low flow system when you match it with amy TP or SpaTouch topside panel (some exceptions may apply)
Supports - ControlMySpa, Balboa Bluetooth Audio, Chromozon3, and Status Pro
Dimensions: 17"L x 4.75"W x 11.5"H

Mainly used at 230v, though it can also be configured for 120v operation.  However, if needing just a 120v control system, see the BP100 series as an alternative.

Wifi compatible, wifi module sold separately if needed

-Can replace any Balboa BP control system* - While using the existing topside that is already installed on the spa

-Replaces any Balboa VS or EL control system* - When you match it with any Balboa TP type or SpaTouch™ topside control panel sold separately as needed.

*Both the Circ pump and Ozone can be converted to 120V, however they will be the same voltage after conversion. (Both 120V or both 240V.)

System (and any replacement board) is typically shipped in Setup 21

*If a 24 hour circulation pump is being installed, it must have no less than a 23 GPM flow. Laing, Grundfos or Waterway Tiny Might pumps do not perform at this rate and cannot be used.